Menu
Your Cart

MoTeC M2R Series ECU

M2R ECU

The M2R Engine Management System (ECU) has been designed to run twin rotor engines.


It is derived from the existing M4 ECU and has specialised software that limits its use to certain engines only.

Apart from the limitations on engine set up, the ECU tuning software has the same functionality as the normal M4 software. This includes all upgrades and the initial free lambda and logging time.

The software can only be configured to run 2 rotor engines with 2 ref sync modes available:

  • Multi tooth mode with 12 teeth on the crank, this is for use with engines up to the series 6 RX7
  • 36-2 for use with dedicated race engines requiring more accurate timing calculations

The M2R includes the new 140 and 141 ignition modes, allowing control of 4 individual coils with rotary split functionality.

This leaves 1 output available for fuel pump or fans if required. If the wasted spark leading mode 102 is used, a second auxiliary output becomes available.

Advantages

  • Ability to run 4 individual coils (only previously available on the M400/600/800)
  • Significantly lower price than an M4

Note
  - An M2R cannot be upgraded to an M4.

The MoTeC M2R Engine Management System (ECU) has been designed to run twin rotor engines and is derived from the existing M4 ECU and has specialised software that limits its use to certain engines only. The M2R includes the new 140 and 141 ignition modes, allowing control of 4 individual coils with rotary split functionality.The MoTeC M2R Engine Management System (ECU) has been designed to run twin rotor engines and is derived from the existing M4 ECU and has specialised software that limits its use to certain engines only. The M2R includes the new 140 and 141 ignition modes, allowing control of 4 individual coils with rotary split functionality.

Brand: MoTeC SKU: MC30-310006
The M2R Engine Management System (ECU) has been designed to run twin rotor engines. It is derived from the existing M4 ECU and has specialised software that limits its use to certain engines only. Apart from the limitations on engine set up, the ECU tuning software has the same functionality as the ..
£0.00
Brand: MoTeC SKU: MC31-326024
The MoTeC M2R ECU Advanced Functions and Logging Upgrade turns your MLS ECU into an MLS Pro ECU with the following;Traction Control and Launch Control (2, 3 or 4 wheel)Gear Change Ignition Cut (flat shifts)Overrun Boost Enhancement (anti-lag)Ground Speed LimitingIndividual cylinder fuel and ignition..
£441.73
Brand: MoTeC SKU: MC31-326026
The MoTeC MLS ECU Wideband Lambda Upgrade allows the use of a single on-board wideband Lambda controller for Bosch LSM sensors. This option is enabled for a free evaluation period of the first 6 hours engine running time when the ECU is first supplied to allow for Engine Calibration and Dyno testing..
£333.68
Brand: MoTeC SKU: MC31-326025
The MoTeC M2R ECU Data Logging Only Upgrade allows recording of all ECU data to the 512Kb internal logging memory and analysing the data with MoTeCs i2 Standard software. This option is enabled for a free evaluation period of the first 6 hours engine running time when the ECU is first supplied to al..
£333.68
Showing 1 to 4 of 4 (1 Pages)